![[personal profile]](https://www.dreamwidth.org/img/silk/identity/user.png){kind=small}
The Big Floppy Hat
Jul. 1st, 2011 08:49 pm
Pattern:
The way I made these bits were pretty much identical to how I made Pattern A and Pattern E. Big pieces of paper or cardbord to get the right size for the look I was going for. The Hat is made in 8 parts instead of 4. the reason is that 4 gives me a square top and I wanted a more rounded outline, hence 8. Then I proceeded the same way as I did when making Pattern piece A.
On to making the hat:
The way I made these bits were pretty much identical to how I made Pattern A and Pattern E. Big pieces of paper or cardbord to get the right size for the look I was going for. The Hat is made in 8 parts instead of 4. the reason is that 4 gives me a square top and I wanted a more rounded outline, hence 8. Then I proceeded the same way as I did when making Pattern piece A.
On to making the hat:
Instructions:
- Cut 8 pieces of D and 4 pieces of F, remember to add seam allowance!
- Sew the four D pieces together along the sides. Fell the seams. This is the top part of the floppy hat. Now onto the brim:
- You need some sort of stiffener to insert into the brim. A straw hat would be ideal. Reading about other peoples efforts here are some other options; Cardboard (don’t like water), Parchment (period and expensive), Plastic sheeting (non period but weather proof), placemats, starched fabric. A straw hat and cut away the top will also work. Depending on the stiffness of your fabric there are the possibility that vlieseline might work for you. You can also sew a piece of milliners wire into the edge to stiffen it. My options were limited at the time so as this was mostly intended as an experiment I landed on the option of two plastic placemats. I cut out the brim in two pieces – pattern F. I proceeded to cut out the fabric, 4 pieces with seam allowance added.
- Put 2 pieces together with right sides facing each other. Sew along the ends and the outer edge. Trim the allowances and corners and turn. I put some decorative stitching close to the edge.
- Insert the stiffener and secure it by putting a seam along the inner edge. If you don’t mind itchy wool on your forehead you may turn in the edges and sew it shut that way instead.
- Make the second half of the brim in the same manner.
The brim beeing made, and I've got help...sort of...
- Put the two halves together with an overlap. Try it on and adjust it to fit your head.
- Sew the two halves together along the inner edge where they overlap and along the edges about 4 cm on both sides.
- Pin the top of the hat to the brim, if the top is slightly large you can just make pleats evenly to adjust the fit. Sew the parts together.
- I decided to put a few stitches from the inside of the hat securing it to the brim about 8 cm from the inner edge so it wouldn’t flop around in the wind, since my fabric isn’t that heavy.
- When this is being written I still haven’t gotten around to lining the inner edge. This is still to be done with something soft, either silk or velvet. I’ll get a strip roughly the length around my head , ca 65 cm with added seam allowance which I’ll fold and tack down then securely sew into place. I will also be adding ties so I can secure it to my head. Since I often visit a certain windy island…
